Use and Care Manual

INSASOR1016

INSTALLATION OF WALL RACK

1. Release the unit from the wall rack by depressing the hooks.

2. Place the wall rack on the oor and against the wall where the unit is to be installed.

3. Using a pencil and the holes provided in the wall rack, make marks on both sides of the rack at the desired height for the bottom of the

wall rack. Although not mandatory, please note that the positioning of the unit makes installation easier with the use of the pre-cut holes.

4. Securely fasten the rack to the wall, making sure that it is level. When drilling into the wall, make sure not to damage any electrical

wiring or other hidden objects.

N.B. The wall where you install this rack must be straight so that the bracket remains at once installed without having to

apply any pressure. If the rack is not at once installed, the hooking mechanism could be compromised and the convector

could unexpectedly release from its rack.

INSTALLATION OF CONVECTOR

ON WALL RACK

1. Insert the lower hooks of the wall bracket into the

lower slots on the rear of the convector.

2. Engage the hooks of the wall rack into the upper

slots on the rear of the convector.

3. Push on the convector to make sure that it is fully

engaged with the wall rack. You should hear the

hooks engage when pressure is applied to the

upper front of the convector.

THE BOTTOM OF THIS UNIT MUST BE INSTALLED AT LEAST 4 INCHES (10.2 CM) FROM THE FLOOR.

The supply wires must be connected in accordance with all effective

building and electrical codes. The bare (ground) wire must be

connected to the green wire in the convector using an appropriate

wire nut. The supply wires (from the electrical panel) must be

connected to the wires labelled “L1” and “L2” in the convector using

appropriate wire nuts.

N.B. This product must be connected by a qualied electrician

as per the wiring diagram to the right and in accordance with

building and electrical codes effective in your area.

Unit

Electrical

box

Connector (marette)

L1 (black)

L2 (red)

Ground (green)

INSTALLATION & ELECTRIC WIRING

ELECTRIC WIRING

N.B. Cut off power supply at circuit breaker/fuse before proceeding with the installation. To reduce the risk of re, do not store

or use gasoline or other ammable vapors and liquids in the vicinity of the heater. Do not mount in contact with combustible

material. Do not mount in close proximity to another unit.

CAUTION – High temperature; risk of re. Keep electrical cords, drapery, furnishings, and other combustibles at least 3 feet (0.9 m)

from the front of the heater and away from the side and rear.

- The unit should be installed at least 4 in. (10.2 cm) from the oor and 6 in. (15 cm) from adjacent walls.

- Before operating the unit, make sure that both the air inlet (bottom) and the air outlet (front) are free from obstruction.