Instructions / Assembly
5
2
1
4
B
A
3
ON OFF
IMPORTANT: Models provided without back-box shall be only
installed with back-box kit-ASSOBB available at your heater
supplier. Do not use any other back-box or retrot.
1. Locate the studs and any other structures that might be inside
the wall.
2. Measure the space required according to the diagrams.
3. Make an opening according to the direction of the desired installation
shown beside.
4. Pull the power cable out of the wall. You will need at least 6 in. of
cable inside the junction box to connect the unit’s wires easily.
3
PREPARING THE SURFACE
FOR INSTALLATION
10"
7 1/2" MIN.
7 5/8"
1. Pivot the fan heater’s front
panel toward the top of the
unit [1] and slide it up [2].
Remove it completely.
NOTE: Be sure to place the
fan heater’s front panel on a
clean surface where it won’t
be damaged.
3.
Lift the top [3] of the mecha-
nical housing [A] and slide it
[4] to remove it from the back
box [B].
4
PREPARING THE FAN HEATER
2. Remove the two screws. Keep
the screws with the front panel.
To protect yourself from the risk of electric shock, turn o the
power to the lead wires from the electrical panel.
2
CUTTING THE POWER SUPPLY