Instructions / Assembly

9
ON OFF
E
C
D
Restore power to the fan heater and make sure the fan heater
works by raising the temperature until the unit starts to heat.
See section Using the fan heater, page 10, to get the
most out of your unit.
9
TURNING THE POWER BACK ON
WARNING: You must set the wall thermostat to fan heater mode as soon as you restore power. If the thermostat
stays in baseboard mode, the fan heater will run intermittently and may overheat.
4. Check that the screw at the bottom of the unit is
inserted in the front panel’s slot [E]. Tighten the screw
to secure the front panel.
BOTTOM VIEW
2. Press the top of the front
panel against the wall, keep-
ing it slightly tilted [C] and
centered with respect to the
mechanical housing.
3. Carefully slide the front panel
down until the hooks be-
hind the front panel [D] are
engaged and then pivot it
toward the wall.