Instructions / Assembly

6
INSLAN0314
INFRARED SENSOR REPLACEMENT
• Disconnect sensor from the electronic board. (FIG.2)
• Eject sensor from the support by pushing the little tabs located on each side of the sensor. (FIG.3)
• Replace sensor and execute the steps in reverse.
MOTOR & BLOWER WHEEL REPLACEMENT KIT
• Disconnect the motor from the electronic board. (FIG. 4)
• Remove the two screws and detach the upper tunnel. (FIG. 5)
• Remove the two screws and serrated bracket that hold the motor. (FIG.6)
• Push on the back motor support until it slides out easily and remove motor & blower wheel kit.
• Replace motor & blower wheel kit and execute the steps in reverse. (
FIG. 7-8)
Verify the wheel turns freely.
-
FIG. 7
FIG. 8
FIG.6
-
FIG. 5
SW1
SW2
ELEMENT
L2/N
ELEMENT
L1
E
L
E
ME
N
T
L2/N
E
LEMEN
T
L1
FIG. 4
FIG.3
EJECTING TAB
SW1
SW2
CONNECTOR
IR SENSOR
SW2
CO
N
NEC
TOR
I
R SE
N
SO
R
SW2
FIG.2FIG.1