User's Manual

Aeris Installation, Service and Troubleshooting Manual
Page | 18
Axle Hose Installation
! WARNING: Before pushing the air line tubing into the axle, disassemble the pass through
fitting and place the components over the end of the air line in this order: See Figure 12
• Pass Through Cap
• Rubber O-Ring
• Pass Through Fitting Body
 Now place a piece of masking tape over the end of the air line or plug the end of it so no
debris can get inside the line as it is being pushed through the axle towards the wheel
end.
Figure 12
• Push the cap, o-ring and pass through fitting back far enough back on air line to have enough air
line to push through tapped hole without getting in your way.
• Route the air line through the axle towards the spindle end on each of the outer tapped holes until
air line is protruding approximately 8” out of the spindle. If air line hangs up inside the axle, you
may need to use something to help fish it through the spindle end. Make sure the air line doesn’t
have any kinks in it.