User's Manual

Aeris Installation, Service and Troubleshooting Manual
Page | 25
• The control box has several mounting options. In all mounting options the 5/16” sealing washer,
lock nuts and flat washers must be used. The sealing washer is always on the inside of the box.
1. Attach the box (without the bracket) directly to a cross member or frame section using the
three 5/16” mounting holes in the bottom of the box. Be sure to leave room at the top for the
door to open up.
2. Use the mounting bracket provided with the Aeris system. The bracket can be mounted using
the holes on the side of the bracket or the holes in the top flange. The control box can then be
bolted to either side of the bracket (holes are symmetrical).
3. The mounting bracket can be welded to the trailer is desired, but the frame must have
clearance holes of the 5/16” mounting hardware (nut and flat washer) on the outside of the
box. The box must be removed from the bracket before welding and the welded area must
have some anti-corrosion treatment such as cold-zinc paint.
Figure 19