User's Manual

Aeris Installation, Service and Troubleshooting Manual
Page | 29
Figure 22
Air Lines to Compressed Air Tank
! IMPORTANT: Open petcock valve on compressed air tank to release air pressure from
tank. Once compressed air is drained from the tank, close the petcock valve.
• Remove large 3/8” Plug from side of compressed air tank.
• Install the 3/8” NPT-M x 1/4” NPT-F bushing.
• Install the 1/4” nipple.
• Install “Inlet” side of the Pressure Protection Valve on nipple.
• Install the 90° swivel elbow 1/4" NPT-M X 1/4” tube/DOT fitting to “outlet” side of PPV.
• Run a piece of 1/4” tubing from the 90° swivel elbow to the “Inlet” side of the control box fitting.
• Make sure the mini ball valve on the “inlet” side of the control box is in the open position. See
Figure 23