User's Manual

Aeris Installation, Service and Troubleshooting Manual

Page | 31

Tire Hose Installation

• Attach air hoses to the hubcap and the inner and outer valve stems. The hose with the 180° fitting

attaches to the outer valve stem. Turn the valve stem swivel nut on the fitting until the rubber

gasket just makes contact with the valve stem, then turn the nut 1/2 turn more to ensure proper

sealing. Now push the hubcap end of the tubing into the brass hose adapter fitting and turn the

nut until the fitting is snug. For final tightening, turn the check port stem and the nut at the same

time using only your fingers. Do not use any type of valve stem extensions. See Figure 24 and

• If installing on Super-Single wheel only one hose is required. See Figure 25

Dual tire hose to hubcap connection Super single tire hose to hubcap connection

Figure 2

! IMPORTANT: Make sure the hose(s) are not touching the tire rim. Contact between the hose and

the rim could damage the rim.

! IMPORTANT: Make sure the tire hose(s) are not stretched so tightly that it puts a strain on the valve

stem or the hubcap fittings. Clock wheels if hoses are not aligned with the valve stems.