User's Manual

Aeris Installation, Service and Troubleshooting Manual
Page | 33
Figure 27
Item Qty Description
1. 1 - Wire Extension for light Used to connect light to light and 7 pin power box.
2. 7 - 10 X 3/4” Self Tap screw Used to attach light and P-clamps to trailer
3. 5 - P-Clamps Used to clamp down wire from light to trailer and to 7 pin power box
4. 3 - Wire Ring Terminal Connectors for end of wires to 7 pin power box.
5. 3 - Wire Female Disconnect Used to connect white, yellow, and brown wire to Aeris controller box.
6. 1 - Wire Butt Splice Used to connect light black wire to yellow wire from controller box
7. 1 - Light Pigtail Used to connect light to wire extension to 7 pin power box.
8. 1 - Light Aeris signal indicator
9. 25 - 6” Tie-wraps Used to secure wiring and airlines to trailer components.
10. 25 – 11” Tie-wraps Used to secure wiring and airlines to trailer components.
• Run the 3 wire cable down through the front of the trailer in conduit or space provided by the trailer
manufacturer. Make sure the cable stays inside the conduit or track between the tractor and the
trailer. Failure to do so may end up causing the wire to be damaged. See Figure 30
• Make sure to route the 3 wire cable under the trailer through the same holes that the brake airlines
and other electrical lines are running through. Make sure to secure the cable every 15 -20 inches
using the tie-wraps provided. Any excess cable that is not being used needs to be cut or bundled
and tie-wrapped to existing cable routings under the trailer. See Figure 28