User's Manual

Aeris Installation, Service and Troubleshooting Manual
Page | 35
• Once wire cable is pulled to the mounted controller box at the back of the trailer cut the cable.
Make sure to leave enough wire to have about 12” of wire inside the control box.
• Pull wire cable into the bottom of the control box through the cable glade. Once wire is inside the
box, tighten the nut to seal up around the cable. Tightening the cable gland will
prevent water from entering the box and helps keep the cable from being pulled on which could
lead to damaging the board inside the control box.
• Next strip the wire jacket from around the 3 wires back about 4” using a jacket stripping tool.
Make sure not to cut insulation around 3 wires inside jacket.
• Next strip 1/4” of insulation from the white, brown and yellow wires.
• Crimp the female wire disconnect (spade) terminals to the white, brown and yellow wires using a
crimping tool.
• Now connect the yellow wire to the “Light” terminal on the board, the brown wire to the “Power”
terminal on the board and the white wire to the “Ground” terminal on the board.
• Make sure to leave a loop at the bottom of the wires on the bottom of the control box. This keeps
water from running down the cable to the electrical board inside the control box. See Figure 31
• Close box cover and snap lid clamps.
Figure 31