User's Manual

Aeris Installation, Service and Troubleshooting Manual
Page | 43
CERTIFICATIONS (USA)
This unit complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC ID: SRA-830
This equipment equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void
the user’s authority to operate the equipment.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. Users and installers must be provided with antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
CERTIFICATIONS (Canada)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Ce dispositif est conforme norme Industrie Canada RSS standard exempts de licence(s). Son utilisation est
soumise à Les deux conditions suivantes: (1) cet appareil ne peut pas provoquer d ’interférences et (2) cet
appareil doit accepter toute interférence, y compris les interférences qui peuvent un mauvais fonctionnement
du dispositif.
This product meets the applicable Industry Canada technical specifications/Le présent materiel est conforme
aux specifications techniques applicables d’Industrie Canada.
IC: 7413A-830
Stemco-USA Stemco-Canada
P.O. Box 1989 5900 Ambler Drive, Units 4 & 5
Longview, TX 75606-1989 Mississauga, ON L4W 2N3
[phone] [phone]
1-800-527-8492 877-232-9111
FAX: [phone] FAX: [phone]