Installation Guide

3. Wood Doors: Once holes are marked, use provided
screws to create a ¼" pilot hole. Use the provided sexed
bolt for the middle hole, and the 1 ¼" #12 screws for the
outside holes.
4. Metal Doors: Once holes are marked, use provided
screws to create a " pilot hole. Use the provided sexed
bolt for the middle hole, and the 1 ¼" #12 screws for the
outside holes. To prepare the center hole, use a " bit to
enlarge the center hole, while drilling through the outer
metal skin. (Be sure to keep the drill perpendicular to the
door while drilling). Remove any burrs and use Loctite
thread locker on all bolt threads.
5. Open door fully and check for any interference issues
with wall or floor mounted door stop.
6. Install instructional decals above door handle and on
mirror, paper towel dispenser or hand dryer.