Use and Care Manual

4
SPECIAL FEATURES
INSTALLATION & MAINTENANCE
The puri er is installed horizontally as close as possible to the point of use. Connection of the inlet and outlet to water
supply and insertion of power plug into 3-wire grounded GFCI outlet is all that is required.
Ordinary maintenance consists of routine cleaning the quartz sleeve (once monthly or more or less frequently where
conditions dictate). Lamp replacement is recommended every 10,000 hours of operation (approximately 14 months of
continuous service).
Typical lter cartridge replacement is recommended every 12 months.
PWP (Pure Water Pack
TM
) version requires install of long reach faucet (included) and connection to sink or ice maker.
Model BIO-1.5
1.5 GPM
Model BIO-1.5 PWP
1.5 GPM
Construction - Bio-Logic
®
chamber is constructed of type 316 stainless steel
and is electropolished and passivated for an attractive nish and dependable
service.
Quick Lamp Change - Exclusive Easy-Off
TM
Retainer Cap enables effortless
lamp replacement without shut down of water pressure or drainage of tank. No
tools required.
Dual Heads - Constructed of type 316 stainless steel, heads may be removed
and rotated and individually oriented for versatility during installation.
Fused Quartz Sleeve - Insures optimum lamp output at normal potable water
temperature.
Mounting Brackets - allow for easier install to secure surface.
Dual Filter Housing - Sturdy, 5 micron sediment lter cartridge removes dirt,
rust, scale, silt, sand and other water suspended particles while the 5 micron
carbon lter removes chlorine, THM’s, pesticides and other related volatile organic
hydrocarbons.
Installation Kit - Includes everything necessary to hook up
entire system - tubing, saddle valve (saddle valve ts feed pipes
between 3/8” to 1/2”) and long reach faucet.
Mounting Bracket - Stainless steel bracket with all system
components factory installed. Unit is ready for hook up under the
sink as soon as it’s removed from carton.
Models BIO-1.5, BIO-1.5 PWP and BIO-3.0
Model BIO-1.5 PWP