Installation Guide

2
© 2012 Kohler Co.
1195742-2-A
Assemble both towel bars with a spacer on each
side of the door panel. Use a hex wrench to
tighten the screws. Do not overtighten!
To install the panel guide, slide the door panels
to one side and slide the guide over the bottom
track expansion mechanism. Align the door
panels with the guide.
Inside the shower, apply a 3/16" (5 mm) bead of
silicone sealant along the entire length of the wall
jambs and where the wall jambs meet the bottom
track.
Outside the shower, apply a 3/16" (5 mm) bead of
silicone sealant along the entire length of the wall
jambs and the bottom track.
On the inside of the shower, hold the guide
against the bottom track and slide the doors from
wall to wall. If the doors bind or do not contact
the bumpers, reposition the rollers to raise or to
lower the glass panels.
Label
Side
Label
Rollers
Label Side
Roller
Label
Identify the outside door panel. The label faces
the outside of the shower. The rollers are on the
same side as the label and face the outside of the
shower.
Identify the inside door panel. The label faces the
outside of the shower. The rollers are opposite the
label and face the inside of the shower.
Lift the inside door panel onto the inside track.
Install with the label facing the outside of the
shower.
23
21
16
12
11
17
22
Recommended Action
A. Remove the door panel from the top track and lower the roller that is closest to the wall. See step 17.
A. Remove the door panel from the top track and raise the roller that is closest to the wall. See step 17.
A. Determine whether door panel top or bottom is closer to the wall and then adjust the roller closest to the wall.
A. Check that the top and bottom tracks press the wall jambs flush against the walls. See steps 5, 6, 7, 8, and 9.
Recommended Action
A. When showering, make sure the inside panel is against the showerhead wall.
A. Adjust the door panel to line up with the wall jamb. See step 17.
A. Check for proper silicone sealant application. See steps 21, 22, and 23. Apply more silicone sealant in the leak
location.
Recommended Action
A. Ensure a gap exists between the bottom track and the door panel. If no gap exists, lower the rollers to the next hole.
B. Ensure the rollers are properly installed. See step 12.
C. Clean any debris in the top track groove.
A. Ensure a gap exists between the bottom track and the door panel. If no gap exists, lower the rollers to the next hole.
B. Ensure the rollers are properly installed. See step 10.
C. Clean any debris in the top track groove.
Symptom: Alignment
1. The top of the door panel is tilted away from the
wall.
2. The bottom of the door panel is tilted away from
the wall.
3. The door panel does not touch the bumper.
4. The wall jamb is not flush against the wall.
Symptom: Water Leaks
1. Water leaks between panels.
2. Water leaks between the wall jamb and
the door panel.
3. Water leaks under the bottom track.
Symptom: Operation (open/close)
1. The outside panel is difficult to move.
2. The inside panel is difficult to move.
WARRANTY
TROUBLESHOOTING
IMPORTANT! Proper application of silicone
sealant is critical to the long-term performance of
your shower. Apply silicone sealant to your
shower door as instructed in the following steps.
20
15
10
Outside of
the Shower
Inside of
the Shower
Outside of
the Shower
Inside of
the Shower
Outside the shower, lift the center guide slightly
and apply a 3/16" (5 mm) bead of silicone sealant
under the guide.
NOTE: When the top track is tightened properly,
the expansion mechanism nut will be seated
against the stationary portion of the top track.
Ensure that the top track pads and the wall jambs
are pressed flush against the wall and that the
shower door frame is installed securely. Expand
the top and bottom tracks if needed.
Lift the outside door panel onto the outside track.
Install with the label facing the outside of the
shower.
18
13
Door
Panel
Vinyl Strip
Outside
of the
Shower
Outside
of the
Shower
Spacers
1/4"-20 Screw
Door
Panel
Towel Bar
x2
Wall Jamb
Pad
Pad
Expansion Mechanism Nut
Top Track
Wall Jamb
Raise the glass.
Lower the glass.
Guide
Side View
Silicone
Sealant
Outside of
the Shower
Cap
Cap
On the top track, slide the caps against the
shower walls.
Remove the protective vinyl strips from the
bottom of both door panels.
14
19
5 YEARS LIMITED
SP2375, 5100 Series, 5300 Series, 5400 Series, 6300 Series, 6500 Series
3 YEARS LIMITED
1500 Series, 1900 Series, 2200 Series, 5900 Series
1 YEAR LIMITED
500 Series, 600 Series, 660 Series, 670 Series, 690 Series, 950 Series, 2300 Series, 3100 Series
Based on the classification specified above, STERLING bath and shower doors are warranted to be free of
manufacturing defects within the time of the specified model's limited warranty from date of sale.
Kohler Co. will, at its election, repair, rectify or replace a fixture when inspection by Kohler Co. discloses any such
defects occurring in normal usage within the time period of coverage stated above. Kohler Co. is not responsible for
removal or installation costs where replacement is indicated. Damages due to improper handling, installation or
maintenance are not considered manufacturing defects and are not covered by this warranty. This warranty is valid
for the original, consumer purchaser only.
To obtain warranty service, contact Sterling, either through your plumbing contractor, home center, wholesaler or
dealer, or by calling or writing Sterling, Consumer Services, 444 Highland Drive, Kohler, Wisconsin 53044,
1-800-783-7546.
TO THE EXTENT PERMITTED BY LAW, ALL IMPLIED WARRANTIES INCLUDING THOSE OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED.
KOHLER CO. AND SELLER HEREBY DISCLAIM ANY LIABILITY FOR SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES. Some states/provinces do not allow limitations on how long an implied warranty
lasts, or the exclusion or limitation of special, incidental or consequential damages, so these limitations and
exclusions may not apply to you. This warranty gives you specific legal rights. You may have other rights which
vary from state/province to state/province.
This is the exclusive written warranty for Kohler Co.