Installation Guide

Instale las jambas murales
Coloque una jamba mural sobre el carril inferior. Alinee los orificios de las jambas
murales con los orificios de la pared.
NOTA: Los tornillos superiores e inferiores deben insertarse en los topes antes de
instalarlos. No apriete demasiado los tornillos, pues se pueden dañar los topes.
Fije la jamba mural a la pared con tres tornillos de cabeza redonda del #8-18 x
1-1/2″.
Repita los procedimientos con la otra jamba mural.
7. Install the Top Track
NOTE: The top track is designed so either side may be positioned facing outward
according to your preference.
Measure the distance from wall to wall above the wall jambs.
Mark the top track at the determined dimension.
NOTE: For best results use a 32-teeth per inch hacksaw and miter box.
Cut the top track on the inside edge of the mark [approximately 1/32″ (1 mm)
from the mark] to allow space for the top track to slide into place easily.
Carefully file the rough edges smooth where the top track was cut, taking care to
avoid damaging finished surfaces.
Position the top track over the wall jambs and gently push down.
Installer le rail supérieur
REMARQUE: Le rail supérieur est conçu afin que chaque côté puisse être positionné
vers l’extérieur selon la préférence.
Mesurer la distance de mur à mur au-dessus des montants du mur.
Marquer le rail supérieur à la dimension déterminée.
Top Track
Rail supérieur
Carril superior
Measure here.
Mesurer ici.
Mida aquí.
Sterling 15 1063216-2-H