Instructions / Assembly

ASSEMBLY INSTRUCTIONS
NOTE: This tree may utilize light sets that are marked for indoor and outdoor use.
However, this tree is recommended for indoor use.
* This box contains one each2’, 3’, 4’ tree. Each tree has 1 or 2 parts.
1. Before you start to assemble your tree, choose a location near a wall
outlet. Assemble the tree stand and place on a level surface.
2. Plastic stand: slide the legs upwards into slots at the base of the trunk
and tap lightly with hammer until firmly fixed. Do not force
legs into base or they may break.
3. Carefully insert the bottom section (II) of the tree into assembled stand.
Make sure the pole is firmly inserted into stand.
4. Insert the tree top section (I) into the bottom section (II).
5. Allow branches to fall into place or gently pull up and out. When
adjusting branches be sure that all wires are free of branch hinges.
6. Connect the plug(s) securely as shown above. Plug the cord into the
wall outlet. Your entire tree should now be lit. If some bulbs do not light,
search for any loose plugs, broken, loose or missing bulbs. (See trouble
shooting section on) Keep tree plugged in while shaping your tree.
Should a light flicker while doing this, check for the bulb(s) that may
have caused the trouble.
7. Begin to shape the branches working from the bottom to the top. Start with tips farthest from
the pole, one to the right, one to the left and one at the center of the main stem.
8. After shaping the whole tree, step back and take an overall look. Shift branches to fill any gaps. Slightly upsweep all
branch tips for a uniform look. Your tree is now ready to decorate and enjoy.
STORAGE:
1. Unplug cord from the wall outlet and remove all ornaments and decorations.
2. Unplug each section from each other.
3. Gently lift off the top and middle sections, and remove the bottom section from the tree stand. Carefully place the tree
in its box and tape it shut. DO NOT STORE TREE IN A DAMP AREA OR IN AN AREA WHERE THE TEMPERATURE
EXCEEDS 100 .
TROUBLESHOOTING INSTRUCTIONS
If Lights Do Not Work:
1. Check whether the cord is properly plugged into the outlet.
2. Be sure there is power to the outlet.
3. Check whether all plugs within the tree are securely connected.
4. Check whether all bulbs are tightly fixed inside the lamp holders.
5. If a bulb is blown, replace the faulty bulb following the below diagram. There are spare bulbs included for easy
replacement.
6. If none of the lights are working, check the fuse in light string. If the fuse is blown, replace the blown fuse following the
below diagram. There are spare fuses included for easy replacement.
WARNING – Risk of Fire and Electric Shock:
1. Read all instructions and warning tags included with this tree.
2. For Indoor Use Only.
3. Do not place near gas or electric heaters, radiator, fireplaces, candles, or other similar sources of heat.
4. Place on a level, hard, flat surface; do not place where tree is likely to wobble due to uneven floors or thick carpeting.
5. Do not use candles on tree.
6. After assembling the tree and adding decorations, make sure the tree is stable. If tree is not stable, shift the weight of
decorations, and use support wires to walls and/or window frames (make sure they are secure also).
7. Do not overload extension cords or power strips, see ratings on those devices and check the rating label of the tree for
compatibility.
8. Do not install near fountains, bathtubs, sinks, or other wet areas.
SAVE THESE INSTRUCTIONS
MADE IN CHINA