Instructions / Assembly

ASSEMBLY INSTRUCTIONS

NOTE: This tree may utilize light sets that are marked for indoor and outdoor use.

However, this tree is recommended for indoor use.

1. Before you start to assemble your tree, choose a location near a

wall outlet. Assemble the tree stand and place on a level surface.

2. Pull apart the legs of the stand so that they are “X” shape. Lock

the stand in position with the single eye bolt on the outside metal tab.

3. Screw three eye bolts through the hole on the inside metal tab.

4. Carefully insert the bottom section (III) of the tree into assembled stand.

Make sure the pole is firmly inserted into stand and turn screws so they

touch tree trunk. Stand tree up and straighten by adjusting screws in or

out then tighten screws.

5. Insert the middle section (II) into the bottom section (III) and the tree top (I)

into the middle section (II).

6. Allow branches to fall into place or gently pull up and out. When adjusting

branches be sure that all wires are free of branch hinges.

7. Connect the plug(s) securely as shown above. Plug the cord into the wall outlet. Your entire

tree should now be lit. If some bulbs do not light, search for any loose plugs, broken, loose or

missing bulbs. (See trouble shooting section on next pg.) Keep tree plugged in while shaping

your tree. Should a light flicker while doing this, check for the bulb(s) that may have caused

the trouble.

8. Begin to shape the branches from the bottom to the top. Start with tips farthest from the pole,

one to the right, one to the left and one at the center of the main stem.

9. After shaping the whole tree, step back and take an overall look. Shift branches to fill any

gaps. Slightly upsweep all branch tips for a uniform look. Your tree is now ready to decorate

and enjoy.

SAVE THESE INSTRUCTIONS

MADE IN CHINA

PAGE 1
ASSEMBLY INSTRUCTIONS NOTE: This tree may utilize light sets that are marked for indoor and outdoor use. However, this tree is recommended for indoor use. 1. Before you start to assemble your tree, choose a location near a wall outlet. Assemble the tree stand and place on a level surface. 2. Pull apart the legs of the stand so that they are “X” shape. Lock the stand in position with the single eye bolt on the outside metal tab. 3. Screw three eye bolts through the hole on the inside metal tab. 4.
PAGE 2
TROUBLESHOOTING INSTRUCTIONS If Lights Do Not Work: 1. 2. 3. 4. 5. Check whether the cord is properly plugged into the outlet. Be sure there is power to the outlet. Check whether all plugs within the tree are securely connected. Check whether all bulbs are tightly fixed inside the lamp holders. If a bulb is blown, replace the faulty bulb following the below diagram. There are spare bulbs included for easy replacement. 6. If none of the lights are working, check the fuse in light string.