Brochure

Pro Charge B
Waterproof Battery to Battery Charger (built to IP68)
Battery Chemistry type selection.
6 battery chemistry types including
AGM, Gel, sealed/flooded lead acid
and LiFePO4.
IP68, totally waterproof,
fully en-capuslated can
be submerged in water.
Pre-Wired and Pre-Fused cables.
1.5 m / 70 inches cable length.
Various activation modes.
Automatic mode works from
sensing voltage. Manual mode
works from switch over ride.
Regenerative braking mode the
chargers stays on down to 12.2V.
Thermal power reduction, allows
for short high power runs to
maximise power transfer.
Boost / Reduce Charging. The Pro
Charge B shall ensure your batteries get
the correct charging profile for your
batteries irrespective of high or low input
voltage.
Suitable for battery banks up
to about 200Ah at 12V.
Multiple units can be used on the same
installation.
The Pro Charge B is a fully epoxy encapsulated, plug and play, battery to battery charger. It
is primarily designed to be put between the starter battery and an appliance battery (trolling /
bow thruster /domestic). The charger puts a load on the alternator and converts that load
into a 4 stage charging profile to provide fast and effective charging to the leisure/domestic
batteries. The whole point of the charger is to charge your batteries up when you drive/cruise
along by fully utilizing your on board alternator. The charger is best suited for alfresco use to
fully utilize its weatherproof casing. Therefore, it tends to be at home on bass fishing boats
charging the trolling motor bank - it can be used in a plethora of other places.
up to 300W rating.
Output charging at 12V,
24V, 36V and 48V. Input
voltages at 12V and 24V.
Battery to Battery chargers / IP68 FULLY WATERPROOF
Input (VDC) Output (VDC) Input Current (A) Size L x W x D Weight (Kg) Code
12V 12V 25A* 230 x 135 x 65 3 BBW1212
12V 24V 25A* 230 x 135 x 65 3 BBW1224
12V 36V 25A* 230 x 135 x 65 3 BBW1236
12V 48V 25A* 230 x 135 x 65 3 BBW1248
24V 24V 13A 230 x 135 x 65 3 BBW2424
24V 12V 13A 230 x 135 x 65 3 BBW2412
NEW
NEW
* 25A for about 30 minutes then drops to about 18A on thermal restriction
Regenerative Braking friendly.
this product can be used in
vehicles with regenerative
braking / smart alternators.
12V 24V 36V 48V
Up to 28A-12V Input
16
t
a
B
o
t
t
a
B
f
o
o
r
p
r
e
t
a
W
R.B.F
Regenerative
raking riendly B F