user manual

SGB Batch Blender with Mitsubishi Controller Page 109 of 118
Feeder Setup This screen allows you to modify the type of each
feeder. In most cases, the user will want to keep
regrind on hopper 3 because that blender has
been specifically designed to handle the regrind.
These settings should only be modified under
special circumstances.
If the blender is configured in “Quick Set” then
one hopper must be configured for Regrind and
only one hopper must be configured for Virgin
material. If this is incorrect, a message will be
given on the Recipe Screen.
12-1-3 Customer Setup Menu
Units This screen allows the user to change the blender’s unit
of measurement. The entire blender can be configured in
either Kgs. or Lbs., while the Target vs. Actual data can
be configured for either regardless of the blender’s units.
Alarm This screen allows the user to configure the feeder type
Setup for each feeder; configure whether a feeder will retry
during the metering of a batch, and enable or disable the
“Out of Material” alarm for any feeder. If a hopper is set
to “Continue on Out of Material” then the blender will
continue to meter the rest of the batch even if this hopper
runs out of material. To configure each hopper, perform
the following steps:
1. Select a feeder by touching the “Select Feeder”
Go back to Sterling
Engineering Only
Directory.
Change Target vs.
Actual Units
Change
Blender’s
Units
Go back to
Setup
Director
y