User Guide

BP1620, BP1628 & BP1640 Granulators Page 36 BP1600
It is important to note that the minimum dimensions
given for the rotor knife and bed knife cannot be
combined simultaneously to produce a cutting
combination.
NOTE: Replacement knife sets and knife resharpening services
are available from Sterling. Contact the Customer
Service Department at [phone].
Figure 5
Bed Knife Sharpening
9-8 Bed Knife Installation & Setting
1. Install the new or resharpened bed knives, and clamps
in the reverse of removal. Make sure the knives are
fully back against the knife adjusting screws and loosen
the adjusting screw checknuts slightly. Do not torque
the hex head screws fully at this point -- snug them
down only.
CAUTION!
New or resharpened knives should be handled with extreme care. It is
suggested that the sharp cutting edge be covered with tape to prevent damage
to the knives or injury to personnel during installation.