Use and Care Manual

P.2/4

JA500T

ASSEMBLY INSTRUCTIONS

DO NOT FULLY TIGHTEN ALL HEX BOLTS UNTIL THE ENTIRE UNIT IS COMPLETELY ASSEMBLED

Step 1: Place Table Top with Leaf (A) upside down on a piece of cloth or carpet to prevent finish from

scratching. Attach Table Leg (B) to the corner block of the Table Top (A) by inserting Flat Washer (3), Lock

Washer (2), Hex Bolt (1) and tighten with Wrench (4). Do not fully tighten.

Step 2: Turn the Table to upright position on flat surface and adjust legs until level and does not wobble.

(*Note: It is recommended to use two or more people to turn the table). Fully tighten all Bolts at this time.

If do not use the Leaf of the Table Top (A). Unlock the Latch underneath the Table Top (A) and pull the

Table Top (A) from both ends. Take the Leaf out of the middle of Table Top (A), close the Table Top (A)

by pushing from both ends. Lock the Latch underneath the Table Top (A) to prevent from sliding. Assembly

of product is now completed.

LOCK

UNLOCK

Leaf

LATCH