Use and Care Manual

P.2/5
DO NOT FULLY TIGHTEN ALL BOLTS AND HEX NUTS UNTIL THE ENTIRE UNIT IS COMPLETELY ASSEMBLED
A
Step 2: Attach Front Leg (C) to the Seat Cus hion (B) by inserting Flat Washer (5), Lock Washer (4),
Medium Bolt (2) into the holes at the rear corner block of the seat box. Tighten all bolts with Allen Key (6)
Step 3: Place the Chair to upright position on flat surface and adjust legs until level and does not wobble.
Fully tighten all bolts with Allen Key (6) provided . Assembly product is now completed.
C
Step 1: Place the Chair Back
(A) on the floor. Attach Seat
Box w/Seat Cushion (B) to
Chair Back (A) by inserting
the Flat Washer (5),Lock
Washer (4), Long Bolt (1) into
the holes at the rear corner
block of the seat box. Attach
Flat washer (5), Lock washer
(4), Short Bolt (3), into the
holes at the rear bar of the seat
frame . Tighten all bolts with
Allen Key (6) .
B
A
B
B
C
4
5
2
6
6
4
5
1
6
5
4
3
SN500S
ASSEMBLY INSTRUCTIONS