Use and Care Manual

P.2/4
YS500PTT/YS500PTL
ASSEMBLY INSTRUCTIONS
DO NOT FULLY TIGHTEN ALL HEX BOLTS UNTIL THE ENTIRE UNIT IS COMPLETELY ASSEMBLED
Step 1: Place Table Top (A) upside down on a piece of cloth or carpet to prevent finish from scratching.
Attach Table Leg (B) to the Table Top (A) by inserting Hex Bolt (1), Lock Washer (2), Flat Washer (3), and
fully tighten with Wrench (4) as the picture below. Do not over tightent.
Step 2: Turn the Table to upright position. (*Note: It is recommended to use two or more people to turn the
table).
Place the Table on flat surface. Unlock the Latch underneath the Table Top (A), and pull the Table Top
(A) from both ends. Inserting the Table Leaf (C) into the middle of Table Top (A), close the Table Top (A)
by pushing from both ends. Lock the Latch underneath the Table Top (A) to prevent from sliding.
Assembly of product is now completed.
LOCK
UNLOCK
LATCH
A
B
B
A
C
B
B
1
2
3
4
1
2
3
4
B
B