Owner's Manual
Table Of Contents
- Owner's Manual
- To The Owner
- About the Balon Series
- Installation Preparation
- Frame Assembly
- Flush Mount Bracket System
- Telescoping (Stand Off) Mount Bracket System
- LED Kit Installation Guide
- LED Kit Diagram
- Attaching the Screen to the Frame (Vinyl & Woven)
- Attaching the Screen to the Frame (Blackhawk UST Material)
- Attaching the Border Trim (Balon Edge Only)
- Installation Troubleshooting
- Caring For & Cleaning the Screen
- Warranty
Stewart Filmscreen – Balón
10
FLUSH MOUNT BRACKET SYSTEM (CONT.)
6. Without the screen attached, hang the assembled frame onto the Flush Mount hanging bar to
ensure that it is correctly mounted (see Figure 4).
Figure 4: Cross section of frame mounted on Flush Mount hanging bar
7. Remove the frame and follow the steps for attaching the screen to the frame.*
(For vinyl & woven snap material, refer to page 17. For BlackHawk UST lace and grommet material,
refer to page 19).
*Note: If an LED kit was purchased, please follow the install guide on the page 14 before
proceeding to screen attachment.