Owner's Manual
Table Of Contents
- Owner's Manual
- To The Owner
- About the Balon Series
- Installation Preparation
- Frame Assembly
- Flush Mount Bracket System
- Telescoping (Stand Off) Mount Bracket System
- LED Kit Installation Guide
- LED Kit Diagram
- Attaching the Screen to the Frame (Vinyl & Woven)
- Attaching the Screen to the Frame (Blackhawk UST Material)
- Attaching the Border Trim (Balon Edge Only)
- Installation Troubleshooting
- Caring For & Cleaning the Screen
- Warranty
Stewart Filmscreen – Balón
13
TELESCOPING MOUNT BRACKET SYSTEM (CONT.)
6. After the frame has been mounted, remove the frame by uninstalling the telescoping mount
wall bracket that is attached to the frame bracket (see Figure 8).
Figure 8: Rear view of frame uninstalled from Telescoping Mount wall bracket.
7. Remove the frame and follow the steps for attaching the screen to the frame.*
(For vinyl & woven snap material, refer to page 17. For BlackHawk UST lace and grommet material,
refer to page 19).
*Note: If an LED kit was purchased, please follow the install guide on the next page before
proceeding to screen attachment.