Owner's Manual
Table Of Contents
- Owner's Manual
- To The Owner
- About the Balon Series
- Installation Preparation
- Frame Assembly
- Flush Mount Bracket System
- Telescoping (Stand Off) Mount Bracket System
- LED Kit Installation Guide
- LED Kit Diagram
- Attaching the Screen to the Frame (Vinyl & Woven)
- Attaching the Screen to the Frame (Blackhawk UST Material)
- Attaching the Border Trim (Balon Edge Only)
- Installation Troubleshooting
- Caring For & Cleaning the Screen
- Warranty
Stewart Filmscreen – Balón
15
LED KIT INSTALLATION GUIDE (CONT.)
3. Once you reach the corner/turn on the frame, make a wide loop with the LED strip so that at least
4-5 LED diodes are hanging in the corner to even out the light field coverage (see Figure 11).
Figure 11: Corner loop for LED coverage
4. Repeat on all four sides, as well as the corners, until you reach the initial starting point.
5. Test out the LED kit with the provided power source before screen material attachment to ensure
the LEDs are working as intended.