Owner's Manual
Table Of Contents
- Owner's Manual
- To The Owner
- About the Balon Series
- Installation Preparation
- Frame Assembly
- Flush Mount Bracket System
- Telescoping (Stand Off) Mount Bracket System
- LED Kit Installation Guide
- LED Kit Diagram
- Attaching the Screen to the Frame (Vinyl & Woven)
- Attaching the Screen to the Frame (Blackhawk UST Material)
- Attaching the Border Trim (Balon Edge Only)
- Installation Troubleshooting
- Caring For & Cleaning the Screen
- Warranty
Stewart Filmscreen – Balón
7
FRAME ASSEMBLY
Unpacking
Use a drop cloth to protect all surrounding surfaces and be sure to unpack carefully in a clean area.
Use special care when handling the screen material so that it does not become soiled or damaged. If
you plan to repack your screen and hardware for transportation to another location, you may wish to
photograph or make a note regarding how it was packed. Keep the original packing material for future
use, if desired.
Frame Assembly Instructions
1. Connect the frame members by matching numbered dots on the ends of the members (see
Figure 1).
⚠
CAUTION
Do not stand on the screen tube or store it on its end. This will cause screen damage. If you are
not installing the screen immediately, make sure it remains horizontal during storage.
Figure 1: Frame assembly rear view
1
4
4
3
3
2
2
1