Owner's Manual

13
Stewart Filmscreen – WallScreen 2.5
WALL BOARD MOUNT (CONTINUED)
7. Remove the boards from
the frame and attach them
to the wall using the
provided hardware or other
appropriate fasteners such
as lag bolts, wall anchors,
molly bolts, wood carriage
screws, etc. (see Figure
11).
8. Attach the screen to the
frame (see pages 16-17).
9. Attach the frame/screen
assembly to the previously
mounted wall boards on
the wall using the 3/4” hex
head bolts (see Figure
12).
Note: On some custom sized
frames, the use of additional
“back support braces” is
required. These vertical
support braces assure parallel
top and bottom frame member
alignment once the screen has
been attached to the frame. Do
not install the screen/frame
without required back braces.
Figure 11: Attaching the
Wall Boards to the Wall
Figure 12: Finished Screen
Attached to Wall Boards
⚠ CAUTION
Be careful not to touch or scratch the
viewing surface.