Owner's Manual

17
Stewart Filmscreen – WallScreen 2.5
ATTACHING THE SCREEN TO THE FRAME (CONTINUED)
4. Place the frame over the screen, snap side down (see Figure 15).
5.
Starting with the snaps on the top corners and then horizontally along the top while lifting the
frame with one hand, snap the screen into the frame. Gently allow the screen to stretch onto
the snaps. Do not jerk, wrinkle, or crease the screen material, as it can be damaged (see
Figure 16).
6.
Lift the frame to a vertical position to finish attaching the sides and bottom row of the snaps
(see Figure 17).
Note: If there are any wrinkles or puckers on the screen, the snaps on the frame can be
adjusted side to side. Lay the frame viewing side down on a clean surface. A movement of
1/16” to 1/8” (1.6mm to 3.2mm) is usually sufficient to eliminate puckers.
Figure 16: Attaching Top Corner Snaps
Figure 17: Attaching Remaining Snaps