User Manual

Applications
RFI-9256 Radio Modem User Manual Page 48 of 96
5.11 Point-to-point Auxiliary I/O
The simplest way to route auxiliary I/Os is in a point-to-point network as shown in Figure 20.
RFI-9256
Master
RFI-9256
Slave
RADIO CONFIGURATION
Unit is a MASTER
Network Address: 61
Hopping Pattern: 13
Rx Address: 1000
PROTOCOL CONFIGURATION
Main Port: Point-to-point to 2000
AUXILIARY I/O CONFIGURATION
Auxiliary I/O Follows Remote ENABLED
Direction: Bit0 = output; Bit1 = input
0 1 … 7 0 1 … 7
RADIO CONFIGURATION
Unit is a MASTER
Network Address: 61
Hopping Pattern: 13
Rx Address: 1000
PROTOCOL CONFIGURATION
Main Port: Point-to-point to 2000
AUXILIARY I/O CONFIGURATION
Auxiliary I/O Follows Remote ENABLED
Direction: Bit0 = input; Bit1 = output
Figure 20: Point-to-point routing of auxiliary I/Os
In this scenario, the master has I/O 0 configured as an output, and I/O 1 configured as an input, while the
slave has I/O 0 configured as an input and I/O 1 configured as an output. I/O2 2 through 7 are not used.
The input applied to I/O 0 on the slave will be mirrored on the master, while the input applied to I/O 1 on the
master will be mirrored on the slave.