User's Manual

USING INTERNAL MENU COMMANDS
©
©©
© RF Innovations Pty Ltd, 1998 Page: 27
234839, Revision 2.2
In this mode the routing table, packet timer and link control parameters and Timers can be set (see
Protocol Configuration Menu on page 27 ).
(H) Honeywell
This is a Honeywell protocol. Honeywell protocol works similar to Modbus in the protocol decoding
and routing except packets are of specific size so there is no need for a packet timer.
In this mode the routing table, and link control parameters and Timers can be set (see Protocol
Configuration Menu on page 27 ).
(3) DNP3
This is the FT3 Frame format (LPDU).
In this mode the routing table, and link control parameters and Timers can be set (see Protocol
Configuration Menu on page 27 ).
(T) TDE
This is an Introl Systems protocol.
In this mode the routing table, and link control parameters and Timers can be set. (see Protocol
Configuration Menu on page 27 ).
(X) Disabled
Disables any transmission of data though the selected port to a remote radio. No protocol or mode is
assigned. The port can still receive and output data sent from a remote radio but cannot reply.
NOTE: The configuration menu will still be accessible on the AUX port.
Protocol Configuration Menu
If a protocol is configurable then this menu will display the available options relevant to the protocol
selected. For example, Figure 6-13 shows a configuration menu for a port, which is assigned to the Hayes
Dialup protocol. The discussion of the protocol dependant configuration menus will be in Protocol
Configuration Menus.
*** Configure Protocol Menu ***
Main Port: Protocol Type: Hayes Dialup
(M) Hayes Command Control Menu
(P) Tx (Out) Packetiser Timer
(L) Link Control Menu
(Esc) Previous Menu
Enter Choice:
Figure 6-13 Hayes Dialup Example of the “Configure Protocol Menu”