User's Manual

USING INTERNAL MENU COMMANDS

©©

234839, Revision 2.2

(P) Tx (Out) Packetiser Timer

The packet timer is used to in conjunction with Modbus protocol. When no data has been received

from a remote modem for the Packet Timer duration then current cache of data is then passed out the

serial port.

To change the Tx (Out) Packetiser Timer value, press (P). The following will be displayed:

Tx (Out) Packetiser Timer requires a timer value or 0 to disable

Enter Timer value in milliseconds (0-1000): 0

The value can range from 0 to 1000ms. It is 0ms by default and corresponds to disabled.

(R) Remote Address

This option only appears when the point-to-point protocol is selected. The remote address option

allows the user to change the Tx Address of the remote unit. In a point-to-point communication this

value needs to be set to correctly maintain a link between two modems.

To change the Remote Address, press (R). The following will be displayed:

Point to Point requires a Tx Address

Enter Remote Tx Address (0-9999): 20

The value can range from 0 to 9999. It is 20 by default.

(L) LINK CONTROL MENU

Please refer to (2) Link Control Menu on page 20.

Protocol Configuration Menus

Depending on the protocol the user has selected, a different menu (or no menu) will be available for

selection. The following sections also contain background information to help the users understand the

functionality of some protocols.

ROUTE MANAGING