User's Manual

USING INTERNAL MENU COMMANDS
©
©©
© RF Innovations Pty Ltd, 1998 Page: 36
234839, Revision 2.2
(S) Serial Port Configuration Menu
The Port Selection Menu, shown in Figure 6-21, lets the user select the desired modes of operation of
each of the two serial ports and shows their current settings.
*** Port Selection Menu ***
Main Port: 19200 Baud, No Parity, 8 Data, 1 Stop, No Flow
Main Port: Packet Timers: OutPut = Disabled, Input = Disabled
Aux Port: 19200 Baud, No Parity, 8 Data, 1 Stop, No Flow
Aux Port: Packet Timers: OutPut = Disabled, Input = Disabled
(M) Main Port
(A) Aux Port
(Esc) Previous Menu
Enter Choice:
Figure 6-21 Port Selection Menu (Serial)
(M) Main Port
– Select to change the serial port settings on the Main Port.
(A) Aux Port – Select
to change the serial port settings on the Auxiliary Port.
Once the desired port is selected the serial port settings menu in Figure 6-22 is displayed. This menu is
the same for both ports.
*** Serial Port Configuration Menu ***
Main Port: 19200 Baud, No Parity, 8 Data, 1 Stop, No Flow
Main Port: Packet Timers: OutPut = Disabled, Input = Disabled
Main Port: Rx Buffer Limit = 1024
(B) Baud Rate Menu
(F) Flow Control Menu
(N) No Parity
(E) Even Parity
(O) Odd Parity
(1) One Stop Bit
(2) Two Stop Bits
(7) Seven Bit Data
(8) Eight Bit Data
(A) Advanced Functions Menu
(D) Set to Defaults
(Esc) Previous Menu
Enter Choice:
Figure 6-22 Serial Port Configuration Menu