User's Manual

USING INTERNAL MENU COMMANDS

©©

234839, Revision 2.2

(N) No Parity / (E) Even Parity / (O) Odd Parity

These selections change the parity used for the serial connection. When a selection is made it is

displayed in the menu but not implemented until the menu is exited.

To select the Parity simply press the corresponding letter.

(1) One Stop Bit / (2) Two Stop Bits

These selections change the number of stop bits used in the serial connection. When a selection is made

it is displayed in the menu but not implemented until the menu is exited.

To select the Stop Bits, simply press the corresponding number.

(7) Seven Bit Data / (8) Eight Bit Data

These selections change the number of data bits used in the serial connection. When a selection is made

it is displayed in the menu but not implemented until the menu is exited.

To select size of the data within a packet, press the corresponding number.

(D) Set to Defaults

This selection restores factory defaults for the selected serial port (see Factory Defaults page 88 for

settings).

(B) Baud Rate Menu

The baud rate can be changed to several different speeds. When selected the following menu shown in

Figure 6-23 is displayed. Both ports use the same menu however the ports are configured independently.

*** Baud Rate Menu ***

Main Port: Baud Rate = 19200

(0) 115200

(1) 57600

(2) 38400

(3) 19200

(4) 9600

(5) 4800

(6) 2400

(7) 1200

(8) 600

(9) 300

(A) 110

(Esc) Previous Menu

Enter Choice:

Figure 6-23 Baud Rate Menu

To select a baud rate select the corresponding number (or character) beside the speed. The default baud

rate is 19200.