User's Manual

USING INTERNAL MENU COMMANDS

©©

234839, Revision 2.2

(R) RTS Control Menu

RTS (Request to Send) is used in flow control. The following menu in Figure 6-28 allows the RTS signal

to be asserted by one of the following conditions.

This menu is not available if the Aux port handshaking is set to hardware.

*** RTS Output Control Menu ***

RTS MODE: RTS Always ON

(0) ONLINE controls RTS

(1) NETWORK LINK controls RTS

(2) CARRIER DETECT controls RTS

(3) Remote DSR controls RTS

(4) Local DSR controls RTS

(5) Remote CTS controls RTS

(6) Local CTS controls RTS

(7) RTS Always ON

(8) RTS Always OFF

(9) RTS disabled

(Esc) Previous Menu

Enter Choice:

Figure 6-28 RTS Output Control Menu

(0) ONLINE controls RTS

RTS is active when the radio unit is ONLINE.

(1) NETWORK LINK controls RTS

RTS is active when the NETWORK LINK is active.

(2) CARRIER DETECT controls RTS

RTS is active when a valid carrier signal is detected from another radio.

(3) Remote DSR controls RTS

RTS is active when a remote radio’s DSR input line is active.

(4) Local DSR controls RTS

RTS is active when the local radio’s DSR input line is active.

(5) Remote CTS controls RTS

RTS is active when a remote radio’s CTS input line is active.

(6) Local CTS controls RTS

RTS is active when the local radio’s CTS input line is active.

Valid control conditions for RTS are ON = +12volts, OFF = -12volts as per RS232 conventions.