User's Manual

USING INTERNAL MENU COMMANDS

©©

234839, Revision 2.2

(7) RTS Always ON

RTS is always set to ON.

(8) RTS Always OFF

RTS is always set to OFF.

(9) RTS disabled

RTS control has been disabled.

(A) Auxiliary I/O Port

This menu configures the auxiliary Input/Outputs described in section Auxiliary Input/Output Port on

page 79. The following menu in Figure 6-29 shows the options available.

*** Auxiliary I/O Config Menu ***

Sample Time = 500 (ms)

Aux I/O follows remote = Disabled

(D) Aux I/O Direction Menu

(P) Powerup defaults Menu

(S) Sample Rate

(F) Aux I/O follows remote

(E) Enable/Disable Aux I/O

(Esc) Previous Menu

Enter Choice:

Figure 6-29 Auxiliary I/O Control Menu

(S) Sample Rate

This allows the sampling time of the I/O port to be changed.

To change the Sampling Rate, press (S). The following will be displayed:

Update Timer value in milliseconds (8-5000): 500

The sampling time can be set between 8ms and 5000ms (5seconds). The default is 500.

(F) Auxiliary I/O Follows Remote

This allows the I/O port to be controlled by another radio. This is used when data needs to be passed

from one radio to another for control applications.

Every time it is selected the function is toggled to either Aux I/O follows remote = Enabled, or Aux

I/O follows remote = Disabled. Default is disabled

(E) Enable/Disable Auxiliary I/O

Whenever this key is pressed the Auxiliary Remote setting toggles between ON and OFF. When OFF

the Aux I/O will not operate and the power up defaults will not be in operation.