User's Manual

HAYES AT COMPATIBLE COMMAND SET
©
©©
© RF Innovations Pty Ltd, 1998 Page: 71
234839, Revision 2.2
Command Description Command Description
I Firmware ID I7 Modem ID
I0 UNIMODEM PnP response I8 Get Connect Type
I1 Return CRC 32 Firmware checksum I9 Internal Temperature in Deg
C
I2 CRC Firmware checksum Error or
OK
I10 Offline time in milliseconds
I3 ROM Revision I11 Average RSSI
I4 ROM Date I12 Average NOISE
I5 Manufacture Date I13 Get current port ID
I6 Modem Serial Number I14 Get Link Status
Table 7-2 Information Commands
Command Description
AAnswer
DDial number
DT Dial number using
tone
H Hang-up modem
H0 Hang up modem
O Go Online
O0 Go Online
Table 7-3 RFI-9256 Connection Commands
Command Description &W &W1 Command Description &W &W1
S0 Rings before answer 0
disables
!
S52 Remote Tx Address (Point to
Point)
S2 ESC character
!
S60 Logging Level
S6 Wait for Dial Tone Timeout S61 UNIX Date/Time seconds since
1970
S7 Wait for Carrier Timeout
!
S62 System/Log Timer in milliseconds
S12 ESC guard time
!
S70 Port Protocol Type
S21 Set Security Code S80 Local Auxiliary I/O
S30 Inactivity Time out
!
S81 Remote Auxiliary I/O
S39 Rx (In) Packetiser Timer S82 Auxiliary I/O Bit Mask (Direction)
S40 Tx (out) Packet Timer 0 to
disable
S83 Auxiliary I/O Bit Power up default
S41 Number of retries for ARQ S84 Auxiliary I/O Sample Timer
S42 Network fail timeout S90 DCD control
S43 Online requests timer S91 RTS control
S44 Hopping Pattern Sequence S100 Port baud rate
!!
S45 Max TX Power S101 Port parity
!!
S47 Frame Time in milliseconds S102 Port data bits
!!
S48 Do Set Frame Bias S103 Port stop bits
!!
S50 Network Address S104 Port flow control
!!
S51 Unit Rx address
Table 7-4 ‘S’ Register Commands
Table 7-3 Notes
The connection commands must appear as the last command on a line.
Table 7-4 Notes
!
in &w1 &w1 or &w must follow for changes to take effect
!
in &w &w must follow for changes to take effect
Gray For Compatibility only (no function)