User's Manual

Appendix C Hayes Reference
Crescendo UHF Half-Duplex User Manual Page 70 of 78
Command
Name
Notes
ATS50
Network Address
ATS51
Radio Address
ATS52
Point-to-point
Destination Address
ATS53
RSSI Trip
ATS54
Current Channel
First channel number is 1, unless Legacy Channel
Numbering is enabled, in which case first channel
is 0.
ATS55[c]
Channel Tx Frequency
c is the channel number. Frequency in MHz. First
channel number is 1, unless Legacy Channel
Numbering is enabled, in which case first channel
is 0.
ATS56[c]
Channel Rx Frequency
c is the channel number. Frequency in MHz. First
channel number is 1, unless Legacy Channel
Numbering is enabled, in which case first channel
is 0.
ATS60
Log Filter
0: Faults
1: Warnings
2: Status
3: Information
4: Debugging
ATS64
Point-to-[multi]point
Receive Addressing
0: Strict
1: Relaxed
ATS65
Clear Event Log
ATS70
Protocol Mode
0: Point-to-point
1: Point-to-multipoint
2: Hayes Dial-up
3: Datagram
4: Log
ATS71
Point-to-point Mode
0: Connectionless
1: Connection Based
ATS90
Main Port DCD Mode
Note that this command cannot have a [p] port
specifier.
0: Always High
1: Always Low
2: Mirrors DTR
3: Mirrors RTS
4: Follows Rx Carrier
5: Follows Tx Enable
6: Follows Online