Instruction Manual

ManualsBrandsSTI ManualsAccessories for electrical1102

- 1 -

Stopper

SERIES

ADA

Compliant

ADA

Compliant

See Testing

Approvals

Photo is a generic representation to reﬂect the many manufacturers of manual pull stations.

· Can be used as a guard against physical damage to manual pull station, with

or without optional warning horn.

· Optional horn has choice of 95 dB or 105 dB at 1 ft.

· Standard red units have “In Case of Fire...” label unless speciﬁed with “no

label” or “custom label” (extra charge for custom label).

· Horn housing is available in red, blue, green or yellow with optional custom

labeling.

· Typical working properties of polycarbonate are -40° to 250°F (-40° to 121°C).

· Three year guarantee against breakage of polycarbonate housing in normal

use (one year on electro mechanical and electronic components).

· With backplate and gaskets, UL Listed to NEMA 3R Standards (IP 44 Rating

equivalency).

We protect the things that protect you.

Summary of content (8 pages)

PAGE 1
Stopper II® SERIES ADA Compliant ADA Compliant · · · · · · · See Testing Approvals Can be used as a guard against physical damage to manual pull station, with or without optional warning horn. Optional horn has choice of 95 dB or 105 dB at 1 ft. Standard red units have “In Case of Fire...” label unless specified with “no label” or “custom label” (extra charge for custom label). Horn housing is available in red, blue, green or yellow with optional custom labeling.
PAGE 2
UL Listed Models Included on this Install Sheet Indoor Use: STI-1100 With horn for flush mounted appliances STI-1100RC With horn for flush mounted appliances includes relay contacts capable of operating from 9-24 VDC remote power or internal 9V battery power STI-1130 With horn and 2” conduit spacer for surface mounted appliances and electrical boxes STI-1130RC Surface mounted version of the 1100RC includes 2” conduit spacer STI-1200 Without horn for flush mounted appliances STI-1230 Without horn, with 2” c
PAGE 3
Specifications (continued) Temperature Range · -40°F (-40°C) to 120°F (49°C) · For temperatures below -4°F (-20°C) recommend using remote power source Warranty · Three year guarantee against breakage of polycarbonate housing in normal use (one year on electro mechanical and electronic components). · Electronic warranty form at www.sti-usa.com/wc14.
PAGE 4
Installation Instructions FIND CENTER OF 1. Separate cover and frame leaving PULL STATION IN CASE OF FIRE - LIFT COVER PULL FIRE ALARM AND USE GIVEN cables attached. Slide power switch, DIMENSIONS TO on back of horn housing, to “OFF” CENTER PULL STATION 4.9375 in. position (Fig. 5). Using frame or optional IN VISIBLE OPENING (125mm) OF COVER. DRILL 2 in. backplate (recommended with all 4 HOLES PER STEP 2.
PAGE 5
SURFACE MOUNT WITH OPTIONS EXISTING PULL STATION INSERT PLASTIC KNOCK-OUT (2) PROVIDED INTO SPACER NOTCH IF CONDUIT IS NOT NEEDED STI-3003 GASKET (USE WITH 1/2 in. CONDUIT) STI-3004 GASKET (USE WITH 3/4 in.
PAGE 6
EXPLODED ELECTRONIC VIEW FACTORY VOLTAGE SETTINGS: BATTERY POWERED UNITS: 9 VOLT REMOTE POWER "RC" UNITS: 24 VOLT USE 24 VOLT SETTING FOR USE WITH 12 VOLT DC INPUT POWER. JUMPER INSTALLED ON "RC" MODELS FOR EXTERNALLY SUPPLIED 12VDC OR 24VDC POWER NOTE: SMALL CONNECTOR ON JUMPER FITS INTO PLUG ON RELAY BOARD THIS JUMPER IS INCLUDED WITH "RC" MODELS FOR USE WHEN INTERNAL 9VDC BATTERY POWER IS REQUIRED.
PAGE 7
Polycarbonate Cleaning Instructions Rinse with water to remove abrasive dust and dirt. Wash with soap or mild detergent, using a soft cloth. Rinse once more, then dry with a soft cloth or chamois. Exercise caution when using water inside enclosure. Make sure unit is completely dry inside before reassembling. To remove grease or wet paint from exterior of cover, rub gently with a cloth thoroughly wetted 3.2 in. A (81mm) with Naptha. Then wash and rinse. (Do not use razor blades.) 3 in.
PAGE 8
2306 Airport Rd • Waterford, MI 48327 Phone: 248-673-9898 • Fax: 248-673-1246 info@sti-usa.com • www.sti-usa.com Safety Technology International (Europe) Ltd. Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999 Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only) info@sti-europe.com • www.sti-europe.com Subject to change without notice. Printed in USA -8- Inst. Sht.