Owner manual

Other Features
Integral Sounder Volume
TheAlertPointLitehastwovolumesettings,High&Low;thisisdeterminedbythepositionofthe
jumperconnectorcongurationshownbelow.
High Volume:Jumperbetweencenterpinandbottompin(factorysetting).

Low Volume:Jumperbetweencenterpinandtoppin
- 4 -
Battery
TheAlertPointLitemonitorstheoutputpowerofthe9VDCbatteryandemitsaperiodic(single)beep
ifthebatteryfallsbelowtherecommendedpowerlevel.Theworkinglifein“standby”conditionisa
minimumof15months:itisrecommendedthatthisbatteryisreplacedatleastevery15months.
Networking only 2 units (Diagram 1) front covers are removed
1. Besurethatbothunitsareswitched“OFF”andfrontcoversareremoved.
2. DIPswitchSW8shouldbe“ON”onbothunits(eachunitexpectstobeconnectedtoa2ndunit).
3. Unit#1:Insertwiresintothenetworkterminalsasshownopposite.
4. Unit#2:Whenconnectingintothenetworkterminals,ensurethatthe“NetworkIn”andthe“Network
Out”wiresareswitchedover(asshownindiagram1).
5. Turnbothunits“ON”usingthemasterkeyswitch.
TEST
6.  Unit #1,presstheoperatingelement.Thiswillsendtheunitintoalarmcondition,causingtheacti-
vationagtodropintoviewandthealarmtosound.
 Unit #2willalsoimmediatelytriggerintoalarm.
7. Resettingthenetworkedunitscanonlybedonebymanuallyresettingtheoriginallyactivatedunit
usingtheresetkey(showingtheactivationag,inthiscaseunit#1).
8. Repeattheabovetestinreversebyactivatingthe2ndunit.
JUMPER CONNECTOR
BOTTOM PIN
DIP SWITCH
Network IN Network COM
Network OUT Network IN Network COM
Network OUT
UNIT 1 UNIT 2
Diagram 1