4 step installation
Step 1 – Clean wall with degreaser (Wall must be dirt, dust and grease free for proper adhesion)
Step 2 - Measure and Cut
Step 3 - Peel and Stick-It! Avoid touching adhesive Overlap the tiles Press firmly on “grout” lines during installation
Step 4 - Apply silicone based sealant on all borders between tile and wall.
FAQ’s Q: I just painted my walls. How long must I wait before putting up “Stick-It” tiles? A: It is recommended to wait a minimum of 3 weeks. Installing “Stick-It” tiles on freshly painted walls will impact the effectiveness of the adhesive. Q: I installed “Stick-It” tiles a week after painting my wall and now they are peeling off the wall. What can I do? A: Should the tile begin to peel, we recommend applying a small amount of 3M’s multipurpose spray adhesive to the back of the tile.
FAQ’s Q: The week after putting up “Stick-It” tiles, the edges connecting one tile to another are separating. Help! A: Should the tiles be separating from each other, do the following: •Peel the tile pack an additional inch. •Apply a conservative amount of glue with a small applicator to the exposed area. •Using pressure reapply to adjacent tile •Super Glue, Gorilla Glue or any thin set adhesive (even sealant) works fine. Q: I put up my “Stick-It” tiles but did not apply the caulking around the border.
FAQ’s Q: I don’t have the steadiest hands in the world, and it take a few tries to get the tiles on straight or the overlap perfect. Will this impact the quality of the tiles? If so, what do I do? A: Once the tile is placed the adhesive will start to set immediately. If you are peeling the tile off the wall to straighten it, or if your overlaps are not perfect, additional adhesive will be required to secure the tile to the wall.