Manualshelf

MSDS

ManualsBrandsSticky Jack ManualsPaintMulti-Pack - 2 16 oz. Bottles of Glue
1234
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
SKIN: Skin sensitization and irritation may develop after repeated and/or prolonged contact with human skin.
EYES: Contact will irritate human eyes.
SAG MATERIAL SAFETY DATA SHEET PAGE 3 OF 4
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
This material will not normally be absorbed through human skin.
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
LD50 for rats is probably above 5000mg/kg.
Irritation of the mouth, pharynx, esophagus and stomach can develop following ingestion.
HEALTH HAZARDS (ACUTE AND CHRONIC)
EYE: May cause irritation with tearing.
SKIN: May cause skin irritation, temporary stain and allergic sensitivity.
INGESTION: May cause irritation and corrosion on the mouth and stomach tissue.
INHALATION: May cause irritation to upper respiratory tract and lungs, breathlessness, cough, respiratory sensitization.
CARCINOGENICITY:
NTP: No
IARC MONOGRAPHS: No
OSHA REGULATED: No
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE
Respiratory symptoms, including pulmonary edema, may be delayed.
EMERGENCY AND FIRST AID PROCEDURES
Eye: Immediately irrigate with flowing water for 15 minutes. Consult a physician.
Skin: Wash off in flowing water or shower.
Ingestion: Do not induce vomiting. Seek medical attention.
Inhalation: Remove to fresh air.
Consult a physician on all above cases.
SECTION VII – PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Major: Evacuate and ventilate spill area. Prevent entry into water system. Wear full protective equipment.
Minor: Absorb with inert absorbent material.
WASTE DISPOSAL METHOD
Follow all federal, state, and local regulations. Fill empty drums with water and let stand unsealed for 48 hours. Triple rinse and
drain. Dispose of empty drums according to federal, state, and local regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Store indoors at room timperature in original, unopened containers. Protect from atmospheric moisture. Replace outage with inert dry
gas such as nitrogen.