User Manual
OPERATION
OPERATION CKT 15 E / CKT 20 E
ENGLISH
WWW.STIEBEL-ELTRON-USA.COM CK 15-20 E / CKT 15-20 E| 5
6. Operation CKT 15 E / CKT 20 E
1
2
26_07_31_0214
1 Temperature selector
2 Timer
6.1 Starting heating
The temperature is infi nitely adjustable. The appliance stops heat-
ing as soon as the selected room temperature has been reached.
Turn the temperature selector clockwise to the required
setting.
6.2 Adjusting the time switch
With the time switch, the appliance heats with full output and
without temperature control.
Turn the Timer clockwise to set any number of minutes to
count down from 0-60minutes.
6.3 Stopping heating / frost protection
This position ensures frost protection. The heater starts automati-
cally if the room temperature drops below the frost protection
temperature.
Turn the temperature selector fully counter clockwise and
ensure that the time switch is set to "0".
7. Cleaning, care and maintenance
The appliance contains no user serviceable parts.
Clean the appliance when cold with ordinary cleaning products.
Avoid abrasive or corrosive cleaning products.
If a pale brownish discoloration appears on the appliance casing,
wipe this off as soon as possible with a damp cloth.
!
Damage to the appliance and the environment
Never spray cleaning spray into the air slot.
8. Storage
When not in use, keep the appliance in a dry place.
9. Troubleshooting
If the appliance does not heat, check the temperature set at the
appliance and the circuit breacker.
The appliance has a safety high limit that shuts the appliance down
if it overheats. After the cause has been removed (for example air
outlet or inlet apertures covered) and the appliance has cooled
down for a few minutes, operation starts again.
If you cannot remedy the fault, notify the contractor who installed
the appliance. To facilitate and speed up your enquiry, please pro-
vide the serial number from the type plate (000000-0000-000000).