Operating Instructions and Installation Instructions

ENGLISH
www.stiebel-eltron.com DHB-E AU| 13
INSTALLATION
Commissioning
11. Commissioning
WARNING Electrocution
Commissioning may only be carried out by a qualified
contractor in accordance with safety regulations.
11.1 Initial start-up
30
60
45
35
40
50
55
°C
el ectronic
30
60
45
35
40
50
55
°C
el ectronic
..
2..
26�02�02�1183
 Open and close all connected draw-off valves several times,
until all air has been vented from the pipework and the
appliance.
 Check for leaks in the appliance screw joints.
 Activate the safety pressure limiter for flow pressure by
firmly pressing in the reset button (the appliance is delivered
with the safety pressure limiter disabled).
 Push the temperature selector plug into the "set tempera-
ture" PCB.
 Fit the appliance cover and secure with a screw.
 Switch the mains power ON.
 Calibrate the temperature. For this, turn the temperature se-
lector fully clockwise then fully anti-clockwise.
 Check the function of the appliance.
 Remove the protective foil from the control fascia.
Appliance handover
 Explain the appliance function to users and familiarise them
with its operation.
 Make users aware of potential dangers, especially the risk of
scalding.
 Hand over these instructions.
11.2 Recommissioning
See chapter "Settings and displays / Following an interruption to
the water supply"
12. Shutting down the system
 Isolate all poles of the appliance from the power supply.
 Drain the appliance (see chapter "Maintenance").