User Manual

OPERATION
Appliance description
14 | Ultronic S/W www.stiebel-eltron.com
WARNING Electrocution
Never lean any objects against the appliance or insert
them between the appliance and the fixing wall.
!
WARNING Injury
The appliance may be used by children aged 8 and up
and persons with reduced physical, sensory or mental
capabilities or a lack of experience provided that they
are supervised or they have been instructed on how to
use the appliance safely and have understood the result-
ing risks. Children must never play with the appliance.
Children must never clean the appliance or perform user
maintenance unless they are supervised.
Never cover the appliance
Never cover the appliance to prevent overheating of the
appliance.
Note
If the appliance is installed in rooms where flue gas, oil
or petrol vapours occur or where work involves solvents
and chemicals, the operation of the appliance can result
in long-lasting nuisance through odours or contamina-
tion of the appliance.
2.3 Safety clearances
!
Damage to the appliance and environment
Maintain the required minimum clearances.
The appliance’s air inlet and outlet must not be obstruct-
ed by any objects.
The minimum clearances of the appliance can be found in chapter
"Specification / Minimum clearances and detection range".
2.4 CE designation
The CE designation shows that the appliance meets all essential
European requirements:
- Low Voltage Directive
- Electromagnetic Compatibility Directive
The maximum permissible mains impedance is indicated in chap-
ter "Specification".
2.5 Test symbols
See type plate.
3. Appliance description
The appliance works without contact. If you hold your hands in
the IR sensor detection range, the appliance fan is automatically
enabled.
Heated air is discharged from the appliance at high speed. Any
moisture left on your hands is removed and your hands are dried.
When you move your hands away from the IR sensor detection
range, the appliance stops automatically after approx.3seconds.
4. Operation
 Shake your wet hands over the sink before drying to reduce
the drying time.
 Hold your hands under the air outlet and rub them together
in the air current.
Note
The IR sensor response area is located approx.3-4cm
below the air outlet. More information on the detection
range of the IR sensor can be found in chapter "Specifica-
tion / Minimum clearances and detection range".
5. Cleaning, care and maintenance
!
Damage to the appliance and environment
Never spray the appliance using a water hose or other
tools. This would let water penetrate the appliance.
A damp cloth is sufficient for cleaning the casing. Never use abra-
sive or corrosive cleaning agents. Go over with a soft cloth if re-
quired.
6. Troubleshooting
Problem Cause Remedy
The appli-
ance does
not start.
No power supply Check whether a fuse or RCD
has blown or tripped in your
fuse box.
Covering the optical proximity
sensor impairs the function of
the appliance. In this case, the
appliance stops after approx.
3seconds to avoid constant op-
eration.
Check whether the sensor sur-
face is clear. Once you have re-
moved any objects, the appli-
ance will work correctly again.
If you cannot remedy the fault, notify your contractor. To facilitate
and speed up your enquiry, please provide the serial number from
the type plate (000000-0000-000000).
The type plate is located at the bottom of the appliance.