STIGA PARK 2WD 11 0 Comb i P r o 12 5 Comb i P r o 8211-0546-03
1 2 1 2 3 4 5 6 7 8 C A B 2
10 9 1/3 12 11 D 13 24 Nm 3
EN ENGLISH 1 GENERAL This symbol indicates WARNING. Serious personal injury and/or damage to property may result if the instructions are not followed carefully. You must read these instructions for use and the machine’s safety instructions carefully. 1.1 Symbols The following symbols appear on the machine. They are there to remind you of the care and attention required in use. This is what the symbols mean: Warning! Read the instruction manual and the safety manual before using the machine.
EN ENGLISH 3.2 Belt 4.3 Mowing advice The cutting deck’s rear section should rest on the floor (it should not be lifted or secured). Install the belt as follows: 1. Set the maximum cutting height. 2. Locate the belt around the machine’s belt pulley (8:B). 3. Tension the belt with the belt idler (8:A)B. The belt idler should be on the left side of the belt viewed from the driver’s position. 4. Lift up and secure the rear section of the cutting deck.
EN ENGLISH 5.3 Service position 1. 2. 3. 4. Activate the parking brake. Set the implement lifter in transport position. Set the highest cutting height. If the deck has electrical cutting height adjustment, disconnect the cable from the machine. See fig. 7. 5. Remove pins and washers. See fig. 2. 6. Hook the belt idler arm on the mount (8:C) 7. Force the belt off the centre pulley (8:B). 8. Grip the front edge of the deck and lift up.
w w w. s t i g a .
