ST IG A VILL A 92 M 107 M 8211-3037-03
1. 2. A C B 3. 4. 5. 6. A+5 A B+5 B 7. 2 8.
9. R 10. L Z L+R X Y W 11. V 12.
ENGLISH SYMBOLS The following symbols can be found on the machine to remind you of the care and attention that are required during use. The symbols mean: Warning! Read the instruction manual and the safety manual before using the machine. Warning! Do not insert your hands or feet under the cover when the machine is in operation. Warning! Watch out for discarded objects. Keep onlookers away. Warning! Before starting repair work, remove the spark plug cable from the spark plug. GB 2.
GB ENGLISH 5. After setting, tighten the screws properly. USE cutting deck can be folded up: 1. Set the cutting height setting to the maximum cutting height. CUTTING HEIGHT 2. Lift the rear edge of the deck with one hand (fig. 9). The cutting height can be varied between a number of fixed positions, from 30 to 85 mm. 3. Push up the catch and release the rear edge of the deck (fig. 9). Item no. 13-2934: The cutting height is continuously variable from 30 to 85 mm. 4.
ENGLISH GB Nm. In the event of a powerful collision, the blades may be bent out. Undo the locking nut X and fold back the blade. Install a new original break bolt V. Tighten the locking nuts X and Z. POSITIVE DRIVE BELT Both blades are powered inside the deck by a positive drive belt. If one of the blades has struck a solid object (e.g. a stone), the belt tension may be altered. This can lead to the positive drive belt ‘over-meshing’ which, in the long term, can damage the blades.
