S T I GA V I LLA R O YA L PRESIDENT S E N ATO R C O M F O RT MASTER 8211-0288-01
VILLA 1. 2 3 1. 2A 1 2B 1 4 7 6 6 5 5 8 8 2b. President - Royal 2a. Master - Senator - Comfort V-R-REGL 9 3.
VILLA 2 5 3 4 5. 4. 95 7. Master - Senator - Comfort - President 6. N OPEN N 8. Royal 9. N N 10. Master - Senator - Comfort - President 11.
VILLA 13. Royal 12. Master - Senator - Comfort - President 0.75 mm 15. Master - Senator - Comfort - President 14. UPPER LOWER 850ml 85 16. 18. 17.
GB ENGLISH GENERAL This symbol means WARNING. Personal injury and/or damage to property can occur if the instructions are not followed carefully. You must read these operating instructions and the enclosed pamphlet “SAFETY INSTRUCTIONS” carefully before starting the machine. SYMBOLS The following symbols are displayed on the machine to remind you of the care and attention required when using the machine. The symbols mean: Warning! Read the instruction book and safety manual before using the machine.
GB ENGLISH Make sure that the parking brake is released when driving. The clutch pedal must be depressed when changing gear. 4. DRIVE PEDAL (President - Royal) NOTE! Make sure that the machine is standing completely still before changing from reverse to forward gear, or vice versa. If a gear does not engage immediately, release the clutch and then press it in again. Engage the gear again. Never force a gear in! Pedal which activates the variable transmission. 1.
GB ENGLISH The towing unit must only be loaded with a vertical force of max. 100 N. The pulling force on the tow unit from towed accessories must be max. 500 N. NOTE! Before using a trailer – contact your insurance company. NOTE! This machine is not intended to be driven on public roads. STARTING AND OPERATING ENGINE CASING The engine casing must be removed to inspect and maintain the engine and battery. Removing: 1. Lift up the two catches on the rear edge (fig. 4). 2.
GB ENGLISH - gear lever in neutral (only Master, Senator, Comfort). - brake pedal pressed down. - driver sitting on the seat. Always check the operation of the safety system before using the machine! With the engine running and the driver sitting on the seat, check as follows: - select a gear, and lift your weight off the seat – the engine should stop (only Master, Senator, Comfort).
GB ENGLISH SERVICE AND MAINTENANCE SERVICE PROGRAMME STIGA’s Service Programme should be followed to keep the machine in good condition in terms of reliability and operational safety, and from an environmental perspective. The contents of this programme can be found in the attached service log. We recommend that an authorised workshop carries out every service. This guarantees that the work is carried out by trained personnel and with original spare parts.
GB ENGLISH The engine oil may be very hot if it is drained off directly after switching off the engine. For this reason allow the engine to cool for a few minutes before draining the oil. 4. Clean the paper filter as follows: Tap it lightly against a flat surface. If the filter is very dirty, replace it. 5. Assemble in the reverse order. Unscrew the oil drain plug in the end of the tube (fig. 11). Petroleum-based solvents such as kerosene must not be used to clean the paper filter.
GB ENGLISH Do not tip the battery enough for battery acid to run out onto your hands and clothing. If this should happen, flush with lots of water. If the battery terminals are coated with oxide, they should be cleaned. Clean the battery terminals with a wire brush and grease them. LUBRICATION - CHASSIS The machine has three grease nipples on the rear axle, which should be lubricated with universal grease after every 25 operating hours (fig. 17).
