Operation Manual

%RWKYHUVLRQV
•
Coat rope rotor bearing bore with
non-resinous oil -
•
slip rotor over starter post - turn it
back and forth so that anchor loop
of rewind spring engages -
Refit the pawl  in the rotor -
fit the washer  on the starter post
- use screwdriver or suitable pliers
to install spring clip 
on starter post and engage it on the
pawl’s peg - the spring clip must
point clockwise - see illustration.
7HQVLRQLQJUHZLQGVSULQJ
•
Make a loop in the unwound starter
rope and use it to turn the rope ro-
tor six full revolutions clockwise.
•
Hold the rotor steady -
•
straighten the twisted rope -
•
release the rotor -
•
let go of rope slowly so that
it winds onto the rotor.
The starter grip must locate firmly
in the rope guide bush.
If the grip droops to one side:
Add one more turn on rope rotor
to increase spring tension.
•
When starter rope is fully extended
it must still be possible to rotate
the rotor at least another half turn.
If this is not the case, the spring
is overtensioned and could break.
Take one turn off the rope.
•
Refit the fan housing.
5HSODFLQJDEURNHQUHZLQGVSULQJ
•
Lubricate the new spring with
a few drops of non-resinous oil.
•
Remove the rope rotor -
see ,,Replacing Starter Rope“ -
•
remove the spring housing
and parts of spring -
•
fit the new spring housing -
bottom plate must face upward -
slip outer spring loop over lug.
•
Reinstall the rope rotor,
tension the rewind spring,
fit the fan housing and secure in
position.
If the spring pops out of its housing
during installation:
refit it in the counterclockwise
direction, starting outside and
working inward.
133BA017 KN
2
1
3
133BA020 KN
133BA021 KN
 