Owner's Manual
You can run chains of different pitches
on this chainsaw - depending on the
chain sprocket (see "Specifications")
The chain pitch must match the guide
bar. The drive link gauge must match
the guide bar groove width.
•
Unscrew nuts and take off cover
•
Turn tensioning screw
counterclockwise until the peg of
the tensioner slide butts against
left end of housing slot.
'LVHQJDJHWKHFKDLQEUDNH
•
Pull hand guard toward the front
handle.
•
Wear work gloves to protect hands
•
Fit the chain - start at the bar nose.
•
Fit the guide bar over the studs -
•
cutting edges on top of bar must
point to right -
•
and engage the peg of the
tensioner slide in locating hole -
•
place the chain over sprocket at
the same time -
0RXQWLQJ
WKH%DUDQG&KDLQ
1
2
1
45BA001 K
143BA004
3
143BA003 KN
143BA034 KN
143BA005 KN
4
5
6
7
4